Ericsson iPECS-100 - Dial Pulse to Tone Switchover

iPECS-LIK
Feature Description & Operation Manual
Issue 6.1
84
2.30 DIAL PULSE TO TONE SWITCHOVER
Description
On a pulse dial CO line, the user can request the system to change the signaling mode from
pulse to DTMF. This allows the user to access outside facilities that require DTMF signals such
as banking services, voice mail, etc.
Operation
To switch from pulse to DTMF while on a pulse CO line
1. Dial “*”, signaling changed to DTMF.
Conditions
1. In a Speed Dial, the “*” will automatically insert a pause before dialing the remaining
digits.
2. This command is only recognized for analog pulse dial CO lines.
3. Dial pulse to tone switchover is not available in the Redial features.
4. When “*” is the first digit of a dialed number, the Display Security feature is enabled
and not Pulse to tone switchover.
5. For VoIP calls, pulse dialing is not available thus; switchover is not required or
supported.
Programming
CO/IP 1 CO Line Type (PGM 141-Btn 4)
2 CO Line Signal Type (PGM 141-Btn 5)
Related Features
 Speed Dial
 Display Security
Hardware