iPECS-LIK
Feature Description & Operation Manual
6.8
CALL FORWARD CO/IP OFF-NET
Description
The System Attendant can forward incoming CO/IP calls to a remote “Off-Net” location. Calls
are forward via a Speed Dial bin. When a call is received, the system will automatically place a
call using the Speed Dial number, dialing the number and connecting the incoming call in an
Unsupervised conference.
Operation
System Attendant
To activate CO/IP Off-Net Call Forward
1. Lift the handset or press the [SPEAKER] button.
2. Press the [FWD] button.
3. Dial “5”, the Off-Net Forward feature code.
4. Dial CO/IP access code to forward, the incoming call.
5. Dial the Speed Dial bin to be used to place the outgoing call, the LED of any Off Net
forwarded {CO}/{IP} button at the Attendant stations will flutter at a rate of 240 ipm.
To deactivate CO/IP Off-Net Call Forward
1. Lift the handset or press the [SPEAKER] button.
2. Press the [FWD] button.
3. Dial “5”, Off-Net Forward code.
4. Dial CO/IP access Code.
5. Dial “#”.
Conditions
1. The System Attendant can forward any CO/IP line, CO/IP Group or all CO/IP calls
using the appropriate CO/IP dial access code. In addition, a Flex button assigned to
a CO/IP line or group may be forwarded using the Flex button.
2. The conditions of the Unsupervised conference feature apply.
3. The conditions of the Call Forward Off-Net feature apply.
4. When enabled, calls forwarded Off net will receive the Off net forward prompt.
5. When enabled, calls forwarded Off net will receive the DTMF repeat tone.
6. To utilize off-net call forward of incoming analog CO line to other analog CO line, a
valid Open Loop Detect Timer should be assigned by programming for the analog
CO lines to prevent CO line lock up when analog CO lines are in use.
To Next Page
Loading...