iPECS-LIK
Feature Description & Operation Manual
2.19
CO/IP ACCESS
Description
Stations can access outgoing CO/IP lines based on CO/IP Group Access programming. iPECS
Phones may use flexible buttons assigned to access a specific {CO} line, {POOL} button for
outgoing calls or a {LOOP} button.
Individual users may be allowed to assign CO/IP access flexible buttons.
Operation
iPECS Phone
To assign a {LOOP} button
1. [PGM] + {FLEX} + [PGM] + “85” + [SAVE]
To assign a {POOL} button
1. [PGM] + {FLEX} + “8x” + [SAVE]
To place an outgoing CO/IP call
1. Lift the handset or press the [SPEAKER] button.
2. Press desired {CO} line, {POOL}, {LOOP} button or dial the CO line or Group
access code.
To answer an incoming CO/IP call
1. Lift the handset or press the [SPEAKER] button.
Or,
1. Press flashing {CO} line, {POOL} or {LOOP} button; lift the handset to speak
privately.
SLT
To place an outgoing CO/IP call
1. Lift handset.
2. Dial the CO line or Group access code.
3. Dial the desired number.
To answer an incoming CO/IP call
1. Lift handset.
Conditions
1. When a user dials “0”, the system will search the preferred CO group for idle CO/IP
line, if there is no idle CO/IP line then the system will search the 1st CO/IP Group
for an idle CO/IP line. The system may continue the search through all CO/IP line
groups for an available line if “1
st
CO/IP Group Override” is enabled.
2. A telephone user not allowed access to a CO/IP line receives error tone when
access is attempted. The station may receive transferred calls on such denied
access lines but will not be able to flash or use the CO/IP line for an outgoing call.
3. A station denied access to a CO/IP line but assigned to have ring for the CO/IP line
will receive ring, a flashing {CO}/{IP} line LED and may answer the call. The user
may transfer the call but cannot make an outgoing call on the CO/IP line.
To Next Page
Loading...