iPECS-LIK
Feature Description & Operation Manual
SLT
To access a Message Retrieval option
1. At any time after the “Number of Messages” prompt, dial a Message Retrieval
Option digit. The system initiates the selection providing any needed prompts.
Conditions
1. The user must begin dialing within the CCR Analysis timer in response to a system
prompt. If the timer expires, the system will disconnect the call and the user will
receive error tone.
2. When the “call sender” option results in an external call, dialing restrictions will be
applied based on the Station COS.
3. If the user remains off-hook after a call placed through the voice mail is complete,
the user will be returned to the previous place in the Voice Mailbox. If the user
hangs up, the VMIM/VSF will recall the user and, upon answer will play “Request
Mailbox Number” prompt.
4. In Admin, VSF is used as the single reference for a parameter that applies to both
the VSF and the VMIM.
5. If you set auto save next message ON, it’s saved automatically after hearing the
new message.
Programming
SYSTEM AUTO SAVE NEXT MSG (PGM 161-Btn 24 - 11)
Related Features
Message Retrieval
Remote Message Retrieval
Voice Mailbox Settings
Class of Service
Hardware
VSF and/or VMIM
2.73.3.5 E-Mail Notification
Description
With the VSF or VMIM, the system stores the voice message and sends an e-mail to the e-mail
address associated with the station as notification of the new e-mail. The voice message can
be attached to the e-mail as a wav file.
Operation
System
System automatically sends e-mail to notify user of new voice message.
To Next Page
Loading...