Ericsson iPECS-100 - DID Call Wait

iPECS-LIK
Feature Description & Operation Manual
Issue 6.1
316
5.8 DID CALL WAIT
Description
If DID call is incoming to a station that is already call connected, this DID call is wait until the
station is answering or the DID/DISA no answer timer is expired. To activate this feature, the
ADMIN field of DID call wait must be set enable. If station has a flexible button of DID call wait,
then it can set this feature via flexible button.
Operation
iPECS Phone
To assign a {DID CALL WAIT} button:
1. [PGM] + {FLEX} + [PGM] + “34” + [SAVE]
To activate/deactivate DID call wait from an iPECS Phone:
1. Press the {DID CALL WAIT} button.
2. Dial activate/deactivate code, “1” or “0” respectively.
Conditions
1. DID call will follow the call routing defined in PGM code 167 after the expiration of
the DID/DISA no answer timer expires.
2. The iPECS Phone must have an appearance button for the DID line.
3. Assigning the ICLID Timer, which enables ICLID routing, for a DID line, disables
DID Call Wait.
Programming
STATION
1
DID Call Wait (PGM 113-Btn 9)
CO/IP LINE
1
ICLID Timer (PGM 142-Btn 14)
SYSTEM
1
DID/DISA Destination (PGM 167)
2
DID/DISA No Answer Timer (PGM 181-Btn 2)
Related Features
 Direct Inward System Access (DISA)
 Direct Inward Dial (DID)
 ICLID Call Routing
Hardware
 iPECS Phone