Ericsson iPECS-100 - Paging to Networked System

iPECS-LIK
Feature Description & Operation Manual
Issue 6.1
188
2. The numbering plan including the representative of mail access assigned in master
system should be included in the numbering plan of QSIG group in slave system.
Programming
SYSTEM 1 Network Numbering Plan Table (PGM 324 – BTN 6)
2 Centralized VMS Assign (PGM 190)
2.70.2.18 Paging to Networked System
Description
A Station User can initialize a page announcement to other systems by dialing a pre-
programmed number or flex button just as if it were a page announcement within the same
system.
Operation
1. Enter the Network Numbering plan code to the Network Numbering Plan Table
(PGM324) as Net a call in caller system.
2. Enter the Network Paging number and select the page type and destination from
the Network Feature Code Table (PGM325) of the called system.
3. Lift the Handset or press the [SPEAKER] button; the System will provides a dial
tone.
4. Dial the Network Paging number of the other System,
OR
5. Press the pre-programmed {NET DSS} button containing the Network Paging
number of the other System.
6. The Called party System will receive a digit stream sent by the Calling party; it will
be analyzed using the Network Feature Code Table to determine the appropriate
destination. If the destination is right, the Called system will distribute the page
announcement to the Stations.
7. The [NETWORK CO] button LED will be extinguished when the Net Page Call is
cleared.