Ericsson iPECS-100 - 2.81 REMOTE CONTROL WITH MOBILE EXTENSION

iPECS-LIK
Feature Description & Operation Manual
Issue 6.1
210
2.73.3.7 Voice Mailbox Settings
Description
The user can program the Mailbox settings for their mailbox including a security password and
a greeting. When a user presses “8” while retrieving messages, the "Mailbox Setting" prompt,
(“To edit your greeting, press one, to edit you password, press two. To return to main menu,
press nine”) is played.
Operation
To program Mailbox settings while “in” the Voice Mailbox
1. Press “8”, for Mailbox settings, the “Mailbox Setting” prompt is received.
for password
1. Dial “7” and receive the “Password Entry” prompt (“Please enter your new password
and press pound when finished. ”).
2. Dial new password.
3. Press “#” and receive the “Reenter Password” prompt (“Please re-enter your
password to confirm and press pound when finished. ”).
4. Dial new password again.
5. Press “#” and receive “Password Confirmation” prompt (“Your password is saved. ”).
for greeting
1. Dial “4” and receive “Greeting Option” prompt (“To listen to your current greeting,
press five to record a new greeting, press seven to return to the main menu, press
nine.”).
2. Dial “5”, to hear your greeting.
Or,
1. Dial “7” and receive “Record Greeting” prompt, (“At the tone, record your new
greeting, press # when done. ”).
2. After beep, record greeting speaking in a normal voice.
3. Press “#” and receive “Greeting Confirmation” prompt ("Your greeting is saved. ”).
for “Mailbox Setting” prompt
1. Dial “9” and receive “Mail Box Setting prompt” (“To edit your greeting, press one, to
edit you password, press two. To return to main menu, press nine”).
Conditions
1. If the user is external, the user must begin dialing within the CCR Analysis time, if
not the call is released.
2. If the dialed number is not recognized, the “Invalid Entry” prompt is played.
3. The user must assign a password (Authentication code up to 12 digits) before
access to the mailbox will be allowed. Note that a greeting need not be recorded.
4. In Admin, VSF is used as the single reference for a parameter that applies to both
the VSF and the VMIM.