iPECS-LIK
Feature Description & Operation Manual
2.18
CALL WAITING/CAMP-ON
Description
Call Waiting is used to notify a busy station that a call is waiting to be answered. The busy
station is notified of the waiting call by a “Camp-On” tone. For users of an iPECS Phone, the
LED of the [HOLD] button will flash.
After receiving a busy signal, the calling station camps on to the called station. The called
station can respond by:
a. answering the waiting call, which places the active call on hold first,
b. sending a silent text or voice message,
c. activating One-Time DND, or
d. ignoring the Camp-On tone.
Operation
iPECS Phone
To activate a Camp-On while receiving Intercom busy tone
1. Press the “*” button, called and calling stations receive Camp-On tone.
SLT
To activate a Camp-On while receiving Intercom busy tone
1. Press the “*” button, called and calling stations receive Camp-On tone.
Conditions
1. The user may only Camp-On to a station in the busy mode. A user may not Camp-
On to a station in DND, in a conference, receiving a Page, etc.
2. The Camp-On procedure is employed by an Attendant or Secretary of an
Executive/Secretary pair to activate DND Override.
3. A Camp-On tone is sent each time the calling user presses the “*” button.
4. A text or voice message, Pre-defined or Custom may be used to respond to a
Camp-On.
Programming
Related Features
Pre-defined & Custom Text Display Messages
DND (Do Not Disturb)
Intercom Call (ICM Call)
Silent Text Message
Voice Over
Hardware
To Next Page
Loading...