iPECS-LIK
Feature Description & Operation Manual
4. Enter the Message contents, up to 24 characters.
5. Press the [SAVE] button, confirmation tone is received, the new Custom Message
is stored and the station returns to idle.
Conditions
1. Only the System Attendant or Administrator can assign the contents of Custom
Messages 11-20.
2. The alphanumeric characters are displayed as they are entered; refer to Station
Speed Dial for entry procedures.
3. Display Message is cancelled if the user activates DND or Call Forward.
4. Custom Text Display Messages and Display Message status are stored in non-
volatile memory to protect against loss during power failure.
5. The calling station must be an iPECS or Ericsson-LG Enterprise digital phone with
display to receive the message.
6. SLTs are notified of an active Display Message with stutter dial tone. iPECS Phones
will have a flashing [FWD] button when there is an active Text Display Message.
7. Activating a Text Display Message does not affect normal operation of the station.
8. Pre-defined Messages 01 to 04 and 06 to 08 permit the user to input auxiliary
information such as time, date or number.
9. The Attendant station can activate a Text Display Messages for other stations.
However, this feature is not available to an Attendant.
Programming
Related Features
Silent Text Message
DND (Do Not Disturb)
Call Forward
Speed Dial
Hardware
iPECS Phone required to receive Display Messages
2.60.1 DND operation in internal call to pre-selected station
Description
When a station is set Pre-selected Message and other station call to the pre-selected station,
The pre-selected station can receive the ring of internal call or not, by [P-MSG DND] Admin. If
[P-MSG DND] Admin of the pre-selected station is ON, the pre-selected station doesn’t receive
the ring and the caller hears DND tone. It is same operation with DND except that the “pre-
selected massage” is printed in LCD of caller.
To Next Page
Loading...