iPECS-LIK
Feature Description & Operation Manual
2.80
CO CALL REROUTING
Description
System can reroute incoming call to CO. If called number matched with compare digits of Table
252, the call are routed to Rerouting number.
Operation
1. Enable Co Call Rerouting ON and Save
2. T-net FoPstn Table(333) is reduced and created new Col Call Rerouting table.
3. If Compare CO Group is not assigned, All incoming calls are compared with
Compare digits.
4. If Compare Co group is 1 and incoming call is co group 2, it doesn’t work.
5. If Compare digits are 454**, called number should be 454xx(xx is any two digits).
6. Item [CO + Rerouting Number] : if co access code is “0” and tel-number is 1234567,
91234567
7. Item [CO + Rerouting Number] : if individual co numbering code is 88 , co is 5 and
tel-number is 1234567, 880051234567
8. Item [CO + Rerouting Number] : if co group numbering code is 8 , co group is 3 and
tel-number is 1234567, 8031234567
9. If you want to reroute Net number, Rerouting Type should be set NET Type.
10. If you want to reroute internal station, Rerouting Type should be set DISA Type.
Example)
Index 0) If Incoming CO digits are matched digit “454” and CO group 1, seize CO 5 and send digit 123456
Index 1) If it’s matched digit “456**” and CO group 2, seize CO group 1 and send digit 123456
Index 2) If it’s matched digit “42*555” and CO group 1, seize First Co and send digit 123456
Index 3) If it’s matched digit “353” and CO group 5, seize CO group 1 and send digit 123456 in case of transit out
of Networking call.
Index 4) If it’s matched digit “401” and CO group 5, work as DISA.
Conditions
1. Caution : If Co call rerouting table is used, Fop table(333) is reduced. And so, if you
don’t like to do it, you should not choice 252 table.
2. Tnet Fop table(333) and Rerouting table(252) is reduced as following by system
capacity.