Ericsson iPECS-100 - 2.62 REGISTRATION & FRACTIONAL MODULE TABLES

iPECS-LIK
Feature Description & Operation Manual
Issue 6.1
125
2.50 LNR (LAST NUMBER REDIAL)
Description
The last number dialed is stored (up to 48 digits) in the station’s Last Number Redial buffer.
The user may request the system redial the last dialed number without the need to dial the
number.
For iPECS Phones with displays, the last 10 numbers are stored in the LNR buffer. The user
may view the numbers using the [VOL UP]/[VOL DOWN] button and select the number to dial
from the list.
Operation
iPECS Phone
To use Last Number Redial using the [Redial] button;
1. Lift the handset or press the [SPEAKER] button.
2. Press the [REDIAL] button.
3. Press the [VOL UP]/[VOL DOWN] button to highlight the desired number.
4. Press [SAVE] or [REDIAL] to dial the number highlighted.
To use Last Number Redial using the LIP-8000 series soft buttons
1. Press the [DIR] soft button.
2. Press the [SPEED] soft button.
3. Dial “*”.
4. Use the Navigation button to select the desired number.
5. Press the [HOLD/SAVE] button to place the call.
SLT
To use Last Number Redial
1. Lift the handset.
2. Dial “552”, the Last Number Redial code.
Conditions
1. For iPECS Phones with display, the redial buffer will store duplicate numbers unless
dialed consecutively.
2. When the CO/IP line used for the original call is busy, the system will select an idle
line from the same CO/IP line Group to place the call.
3. Using Last Number Redial will cancel Automatic Called Number Redial if active.
4. The LNR buffer is not stored in non-volatile memory and is erased if power to the
system is lost.
5. Manually dialing a Flash during an outgoing call will cause only those digits dialed
after the Flash to be stored in the LNR buffer.
6. LNR applies to both CO and VoIP calls.