Ericsson iPECS-100 - System Speed Zone (Groups)

iPECS-LIK
Feature Description & Operation Manual
Issue 6.1
155
7. Press the [SAVE] button.
8. If desired, enter a name, see alphanumeric entry chart under Station Speed Dial.
9. Press the [SAVE] button.
Conditions
1. Accessing an empty Speed Dial bin will return error tone.
2. A Speed Dial number can be assigned to use a CO/IP Line/Group. If the assigned
line is busy, a line from the same group will be selected. If all lines in the group are
busy, the user may queue for the next available line.
3. All Speed Dial numbers are stored in memory protected from power loss.
4. The CO/IP line used for a Speed Dial is presented to a direct appearance on the
iPECS Phone. If there is no direct appearance at the station, a {POOL} or {LOOP}
button is used as the appearance for the line.
5. The user may pre-select the CO/IP line for a Speed Dial number, overriding the
CO/IP line assignment in the Speed Dial bin.
6. A name can be entered for a Speed Dial number to permit access from the Dial-by-
Name directory.
7. If a Speed Dial number contains a “Dial Tone Detect” command, Flash as the first
entry in the bin, and dial tone detect is enabled for the CO line, the system must
detect dial tone before dialing the Speed Dial number.
Programming
STATION
1
Speed Dial Access (PGM 112-Btn 8)
SYSTEM
1
CO Dial-Tone Detect (PGM 160-Btn 3)
TABLES
Related Features
1
System Speed Zone (PGM 232)
 CO Line Flash
 Dial-by-Name
 Display Security
 Keypad Facility
 LNR (Last Number Redial)
 Dial Pulse to Tone Switchover
 Save Number Redial (SNR)
 Speed Dial Pause Insertion
 System Speed Dial
 System Speed Zone (Groups)
Hardware
2.64.5 System Speed Zone (Groups)
Description