iPECS-LIK
Feature Description & Operation Manual
Operation
To retrieve MWI message
1. Press the flashing [MSG/CALLBK] button and dial 2.
2. MWI contents (CLI number, date and time, the calling count from the same CLI) will
be shown on LCD.
700100
mm/dd hh/mm CNT:01
3. Press the [▲▼] button. The previous or the next MWI is displayed.
To delete the current CLI Message and see the next one
1. Press “*” button.
2. Current MWI message is cleared with a confirmation tone and the next MWI
message is displayed.
To make a call back
1. Retrieve MWI with pressing the flashing [MSG/CALLBK] button and the [▲▼]
button.
2. Press [SAVE] button.
3. Then system makes a net call according to MWI data.
Conditions
1. MWI is applied to LCD panel installed station only.
2. When system makes a call back according to MWI data, the CO line is selected
within the network CO group.
Attribute (PGM114-BTN10 : CLI Message Wait)
Networking Basic Attribute (PGM 320)
Networking CO Line Attribute (PGM 322)
Network Numbering Plan Table (PGM 324)
2.70.2.8 Net Call Forward – Unconditional
Description
It is possible for a user to remotely forward to another station immediately over the network.
Engineering notice).
Currently, iPECS system supports both rerouting and join method by admin programming.
Operation
To activate Net Call Forward
1. Press the [SPEAKER] button and the [FWD] button.
2. Dial Net Call Forward code “1”, and dial the station number of another system. The
[FWD] button will be flashing and a confirmation tone will be provided if allowed.
3. Dial the station number that is set Net Call Forward to a station of another node.
To Next Page
Loading...