iPECS-LIK
Feature Description & Operation Manual
2.71
TRAFFIC ANALYSIS
Description
The iPECS monitors, stores and periodically or upon request outputs various traffic statistics
covering system resources. The output from the system can be used to:
Monitor and evaluate system performance
Observe usage trends and recommend possible corrective actions,
Determine possible trunk problems, i.e. blocking level too high, and/or
Recommend system upgrades.
Attendants enable Periodic Reporting. Once enabled, the system continues to monitor and
output the requested report until Periodic Report is disabled. On-demand reports selected by
the System Attendant are output only upon request. The Traffic Report is sent to the defined
system RS-232 or TCP port.
System resources covered by Traffic Reports are:
Attendant Traffic Report
Call Summary Report
Hourly Call Report
H/W Unit Usage Summary Report
CO Summary Report
Hourly CO Report
Summary Traffic Reports cover one of five Analysis periods selected at time of print:
1. Today’s peak activity hour (within 24 hours)
2. Yesterday’s peak activity hour (24 hours prior to Today’s activity)
3. Last hour activity
4. Today’s total activity
5. Yesterday’s total activity
Operation
System Attendant
To print the All Summary Traffic Report
1. Press the [PGM] button.
2. Dial “0122”, the All Summary report code.
3. Select Analysis Period (‘1’-‘5’).
4. Select hour for print (“00”-“23”).
5. Press the [SAVE] button.
To cancel the periodic All Summary Report
1. Press the [PGM] button.
2. Dial “0123”, the cancel All Summary report code.
3. Press the [SAVE] button.
To Next Page
Loading...