iPECS-LIK
Feature Description & Operation Manual
6.10
DAY/NIGHT/TIMED/SCENARIO RING MODE
Description
The system clock automatically controls the Ring Mode. Ring assignments are applied based
on the time of day and day of week. Four modes of ring (Ring Assignments) are provided, Day,
Night ,Timed and Scenario.
The Attendant controls the system Ring Service mode changing from Auto Service Mode to
Day, Night ,Timed or Scenario service mode. Based on the service mode selected, different
ring assignments, COS and answering privileges are invoked for the system users.
Operation
System Attendant
To change Day/Timed/Night Ring Mode manually;
1. Press the [DND] button.
2. Dial 1~5. (1: Day mode, 2: Night mode, 3: Timed mode, 4: Auto Service mode, 5:
Scenario mode)
3. If you set Scenario mode(5), you should set scenario group(MFIM100/300/600 : 01
~16, MFIM1200: ~32).
4. Press the [HOLD/SAVE] button.
To set Day/Timed/Night Ring/Scenario Mode automatically (Auto Service Mode Control)
1. Press [PGM] button, [PGM] button LED flashes 60 ipm, [SPEAKER] LED lights
steady.
2. Dial the Attendant Station Program code “#8” to toggle between manual and Auto
Mode control.
Conditions
1. Only Attendants can change Day/Timed/Night/Scenario Ring Mode for the system
manually and program the Auto Ring Mode Selection Table.
2. Stations receive incoming ring for CO lines based on the database assignments and
the system mode (Day/Night/Timed/Scenario) when the call arrives.
3. When Auto Ring Selection Table is programmed, the ring, COS and CO/IP access
mode are changed automatically based on the times assigned in the table.
4. The System Attendant always has manual control of the system mode by
enabling/disabling the Auto Service Mode Control.
5. If you want to set manually Scenario mode in attendant, you should program
Scenario group of System call routing table(PGM 251).
CO Line Ring Assignment (PGM 144)
External Control Contact (PGM 168)
Auto Ring Mode Selection Table (PGM 233)
System Call Routing (PGM 251)
To Next Page
Loading...