iPECS-LIK
Feature Description & Operation Manual
Programming
SYSTEM 1 Networking Basic Attribute (PGM 320)
2.70.2.6 Net Conference
Description
A call to a station on one node is able to conference in a party on any other node. Members of
conference must be allowed up to 3 stations of the network.
Operation
To make a Net Conference
1. Press the [CONF] button during conversation through the network call.
The exiting call is on hold and an ICM dial tone is provided.
2. Make a Net Call to another station of other node.
3. Press the [CONF] button when 3’rd party answers.
The second call is on hold and an ICM dial tone is provided.
4. Press the [CONF] button again at master station. All parties can make a
conversation.
To clear a Net Conference
1. Any station in the net conference hangs up during the conference.
2. The net conference will be cancelled and the network path will be cleared.
Conditions
1. Multi-line conference time is not applied on 3 party conference of networking.
2. Standard IP phone cannot be a master station of the Net Conference.
Engineering notice)
When IP phone sends Invite Setup to Non-IP phone, this message will be rejected.
When Non IP phone is going to invite IP phone, normal Setup message should
send to the IP phone instead of Invite Setup message.
Programming
SYSTEM 1 Networking Basic Attribute (PGM 320)
2 Network Numbering Plan Table (PGM 324)
2.70.2.7 Message Waiting Indication (MWI)
Description
MWI is the same meaning of CLI (Calling Line Indication) message wait service. As usual, in
normal ISDN call, a station can leave a message wait for an unanswered station of another
node, if CLI message wait is enabled. MWI is indicated by CLI message on station LCD panel.
Also, it can be supported by supplementary service (without CLI) when press [MSG/CALLBK]
button during hearing ring back tone at Net call.
To Next Page
Loading...