iPECS-LIK
Feature Description & Operation Manual
5.19
PRIME LINE IMMEDIATELY/DELAYED
Description
When a user goes to an off-hook state, the system normally provides ICM dial tone. If desired,
a station can be assigned to access a pre-assigned system resource (Prime Line). The Prime
Line can be any of the Idle Line Settings:
Seize a CO/IP Line,
Call another station,
Activate a Flex button feature.
Call to pre-assigned Hunt group.
Call to pre-assigned station Speed.
Call to pre-assigned system Speed.
Prime Line access can be defined as immediate or delayed. When assigned immediate, upon
an off-hook event, the system provides access to the Prime Line. With Delayed Prime Line, the
station user receives normal Intercom dial tone for the Prime Line Delay timer and after the
delay, the Prime Line is accessed.
Operation
iPECS Phone
To access the station’s Prime Line
1. Lift the handset or press [SPEAKER] button and take no action, Prime Line as
assigned will be accessed.
Conditions
1. Any of the station’s Flex buttons may be assigned as the Prime Line. When the
user lifts the handset or presses the [SPEAKER] button, the system will act as if
the user had pre-selected the button prior to going off-hook.
2 Selection of another Flex button or Feature button just prior to an off-hook event will
override the Prime Line assignment.
3 SLT can use the Flex Button Feature of Idle Line Selection with a Speed Bin
Number.
4 When Delayed Prime Line is set, the user must wait, taking no action until the
Prime Line is accessed. The user receives ICM dial tone during this period and
may dial any valid numbering plan digit(s) or select a Flex button or feature button.
5 If the Prime Line Delay Timer is greater than Dial tone timer, the Delayed Prime
Line will not activate. It will be necessary to reduce the delay timer or extend the
Dial tone timer.
Programming
Prime Line setting (PGM 113-Btn 7)
Idle Line Selection (PGM 121)
Prime Line Delay Timer (PGM 182-Btn 6)
To Next Page
Loading...