Ericsson iPECS-100 - Save Number Redial (Snr)

iPECS-LIK
Feature Description & Operation Manual
Issue 6.1
332
5.21 SAVE NUMBER REDIAL (SNR)
Description
The last dialed number on a CO/IP call may be stored (up to 48 digits) in a buffer for future
redial. This number is saved in memory until the user requests a new number be stored.
Numbers dialed for subsequent calls do not affect the Save Number buffer.
Operation
iPECS Phone
To save a dialed number, while on a CO/IP call
1. After dialing and before hanging up, press the [SAVE] button.
To save a dialed number, while on a CO/IP call using the LIP-8000 menu
1. After dialing and before hanging up, press the [RIGHT NAVIGATION] button.
2. Locate and press the [SAVE] soft button.
To dial a saved number
1. Lift the handset or press the [SPEAKER] button.
2. Press the [SPEED] button.
3. Dial “#”.
To save a dialed number, while on a CO/IP call using the LIP-8000 menu
1. Press the [DIR] soft button.
2. Press the [SPEED] soft button.
3. Dial “#”.
Conditions
1. The saved number can be a maximum of 48 digits.
2. Dialing the saved number will automatically seize the CO/IP line that was used for
the original call. If the CO/IP line is busy, a CO/IP line from the same group will be
selected and the saved number dialed. If all CO/IP lines from the group are busy,
the user will receive All Lines busy tone and may queue.
3. If user presses the [SAVE] button after seizing a CO/IP line without dialing, the
Save Number Redial buffer will be erased.
4. If there is no {CO}/{IP} button, the call will be presented on a {POOL}, or {LOOP}
button.
5. Save Number Redial is protected from power failure.
6. Manually dialing a Flash during a CO call will cause only those digits after the Flash
to be stored and re-dialed as the Save Number Redial.
Programming
Related Features
 Station Speed Dial
 System Speed Dial
 LNR (Last Number Redial)
 CO Line Flash
Hardware
 iPECS Phone