iPECS-LIK
Feature Description & Operation Manual
4.15.2 Calling/Called Party Identification
Description
The iPECS system receives calling party identification in the ISDN call Set-up message, CLIP-
Calling Line Identification Presentation. The answering party identification, which may be
different from the called party, is received in the ISDN connect message, COLP (Connected
Line Identification Presentation). When provided, the LCD of iPECS Phones displays the
identification, which is included in call records. The received identification may be sent to a
selected serial port.
iPECS Phone Display:
LINE RINGING
CLI 03438502821
CLI Serial output:
record at ring start:
AA : BBBBBBBBCCC
record at ring stop
AA : BBBBBBBBCCC : DDDDDDDDD(EEE) -> FFF
record at answer
AA : BBBBBBBBCCC : DDDDDDDDD(EEE) -> FFF
Where:
AA – ISDN CO line number
BB…B – Line Identification received
CCC – Called station
DD…D – Speed Dial name
EEE – Speed Dial bin number
FFF – Answering station
The system will also compare the identification to the Speed Dial bins. If a match exists, the
Name of the Speed Dial bin may be displayed in place of the number, CO/IP Name display.
The system will send calling and answering party identification in the appropriate messages to
the ISDN based on the database. Identification messages may be restricted, not reported, the
far-end user. Calling Line Identification Restriction and Connected Line Identification Restriction
may be enabled in the system database or by {CLIR} and {COLR} Flex buttons.
Operation
System
Operation of this feature is automatic.
iPECS Phone
To program {CLIR} button,
1. [PGM] + {FLEX} + [PGM] + “81” + [SAVE]
To program {COLR} button,
To Next Page
Loading...