iPECS-LIK
Feature Description & Operation Manual
5.2
AUTO CALLED NUMBER REDIAL (ACNR)
Description
This feature allows a station user to request and have the system retry a busy or no answer
external call until the call is connected or the feature is cancelled.
This feature is working on SLT also.
Operation
iPECS Phone
To activate ACNR while receiving busy, no answer
1. Press the [REDIAL] button.
2. Hang-up handset, or press [SPEAKER].
To cancel ACNR while idle
1. Press flashing [REDIAL] button.
To cancel ACNR during an ACNR attempt
1. Lift the handset or press the [MUTE] or flashing [REDIAL] button.
SLT Phone
To activate ACNR while receiving busy, no answer
1. In SLT, outgoing call is established.
2. Outside destination is no answer or busy.
3. Press and release the hook-switch, the intercom dial tone should be heard.
4. SLT user press ACNR code.
5. While on waiting state, SLT user hears MOH.
System
1. The system initiates the ACNR process, starting the ACNR Pause Timer.
2. At expiration of the timer, the system activates the station’s speakerphone with the
microphone in the mute mode.
3. The system attempts the previous call.
4. When the called party answers, the user may answer by lifting the handset or
pressing the [MUTE] button to communicate with called party.
Conditions
1. Four timers and a retry counter can be programmed.
ACNR Pause Time Time allowed between ACNR retry.
ACNR Delay Timer At expiration of Pause Timer, if no line is available, the
system will wait for delay timer before retry.
ACNR Tone Detect After dialing, the system will abandon retry if no tone or
answer is detected within the Tone Detect time.
ACNR Retry Count Count determines the number of times system will retry
before ACNR is automatically cancelled.
To Next Page
Loading...