iPECS-LIK
Feature Description & Operation Manual
4.5
CO/IP RING ASSIGNMENT
Description
Each station in the system can be programmed to provide an audible signal when the system
detects an incoming call on specified CO/IP lines. Separate ring assignments are made for Day,
Night and Timed Ring operation mode. In addition, the audible signal at the station can be
delayed by 1 to 9 ring cycles allowing other stations to answer the call first.
Operation
System
Operation of this feature is automatic.
Conditions
1. Separate assignments are made for stations to ring in the Day, Night and/or Timed
Ring mode.
2. Audible alerting for an incoming VoIP call is based only on the derived IP Address.
3. A busy station receives muted ring or Call Waiting tones as appropriate for the
station’s Off-hook ring assignment.
4. The system Ring mode can be selected manually or automatically. In the Automatic
mode, Day/Night selection is determined based on the Automatic Ring Mode
Selection table. The Attendant has manual control over the Ring mode selection.
5. The LCD of the Attendant station will display Night and Timed Ring Mode and the
[DND] button LED will flash.
6. If a CO/IP line is not assigned to ring at any station, incoming calls on the CO/IP line
will ring the first available Attendant.
Programming
CO/IP 1 CO Ring Assignment (PGM 144)
TABLES 1 Auto Ring Mode Selection Table (PGM 233)
Related Features
Day/Night/Timed/Scenario Ring Mode
Auto Service Mode Control
Off-Hook Signaling
Hardware
To Next Page
Loading...