iPECS-LIK
Feature Description & Operation Manual
2.82
PREFIX DIALING TABLE
Description
PGM 206 – Prefix Dialing Table. With this table, three features can be supported.
1. Analog CO Call Charge with NPR metering.
2. SIP Direct dialing with no wait inter-digit timer.
3. ISDN Prefix Call – ISDN enblock Dialing with Prefix Call Setup.
If first some digits(up to 8 digits) of outgoing dial number are matched with Prefix Code of each
table, this table can start work. By each Co-line(PGM 142 – F20), Table ID(0-6) can be set.
This table ID(PGM 142 – F20) is associated with PGM 206 – each table ID.
Operation
Analog CO Call Charge with NPR metering
1. Outgoing Call is established with analog Co-line.
2. Outgoing digits are matched with prefix code.
3. If Call Charge Timer is set to proper value(ex : 30 sec), call metering pulse is
calculated one time per this timer.
4. For example, If Call charge timer is 30 sec, Call duration is 5 minute, and SMDR
Cost Per Metering Pulse is 1.5$, then Call Cost is [1.5 * 10 = 15$].
SIP Direct dialing with no wait inter-digit timer
1. Outgoing Call is established with SIP Co-line.
2. Outgoing digits are matched with prefix code.
3. If total dialing digits are same as MAX DIGIT, then SIP outgoing call established
directly.
4. So, user need not wait until inter-digit timer expiring.
ISDN Prefix Call – ISDN enblock Dialing with Prefix Call Setup in Russia
1. Outgoing Call is established with ISDN Co-line.
2. Outgoing digits are matched with prefix code.
3. If total dialing digits are same as MAX DIGIT, then ISDN outgoing call is established
directly. So, user need not wait until inter-digit timer expiring.
4. If total dialing digits are less than MAX DIGIT, then ISDN outgoing call is
established after inter digit timer expiring.
5. If total dialing digits are less than MIN DIGIT, then ISDN outgoing call is not
established although prefix code is matched.
6. When ISDN setup is established, Num Of Type, Numbering Plan, Sending
Complete option is applied.
Conditions
1. If outgoing dialing digits are not matched with prefix code, this feature is not working.
2. Table ID is used commonly at three feature.
3. In case of Analog Call Charge, related program fields are Prefix Code, Call Charge
Type, Call Charge time.
4. In case of SIP direct outgoing, related program fields are Prefix Code, Max Digit.
To Next Page
Loading...