iPECS-LIK
Feature Description & Operation Manual
2.42.4 System Hold
Description
CO/IP lines may be placed in a waiting state such that other stations in the system are able to
access the CO/IP line. Stations must have access to the CO/IP line in the system database to
access the held call.
If the call remains on hold at expiration of the System Hold Recall Timer, normal Hold Recall
will apply.
Operation
iPECS Phone
To place a call on System Hold
1. Press the [HOLD] button.
To access a call from System Hold
1. Lift the handset or press the [SPEAKER] button.
2. Press the {CO}/{IP} line button.
Or,
1. Lift the handset or press the [SPEAKER] button.
2. Dial “8#”, the Held CO/IP Call Access code.
3. Dial the CO/IP line number.
SLT
To place a call on Exclusive Hold
1. Momentarily press the hook-switch.
2. Dial “560”, the System Hold feature code.
To access a call from System Hold
1. Lift the handset.
2. Dial “8#”, the Held CO/IP Call Access code.
3. Dial the CO/IP line number.
Conditions
1. When a CO/IP line is placed on System Hold, the button LED will flash at 30 ipm
and wink at the holding station and will flash at all other stations.
2. A call on System Hold can be retrieved from any station allowed access to the
CO/IP line in the system database using the CO/IP line button or the Held CO/IP
call access code.
3. The LED of {LOOP} and {POOL} buttons will display the CO/IP line status.
Programming
SYSTEM 1 Hold Preference (PGM 160-Btn 7)
2 Attendant Recall Timer (PGM 180-Btn 1)
3 I-Hold Recall Timer (PGM 180-Btn 5)
To Next Page
Loading...