iPECS-LIK
Feature Description & Operation Manual
2.45
IN-ROOM INDICATION
Description
A supervisor can press the In-Room Indication button and [HOLD/SAVE] button when in an
idle state; then each Station’s In-Room Indication LED will illuminate.
10 groups can be programmed. Each group has at most 20 members excluding Supervisor.
Operation
To program a flexible button as the “In-Room Indication button”
1. Press the [TRANS/PGM] button and the flexible button to be assigned.
2. Dial the code (TRANS/PGM + 9* + Room NO(bin no))
3. Press the [HOLD/SAVE] button.
To Active or Deactivate In-Room Indication button,
1. Check if Supervisor station is the idle state and In-Room Indication button is
programmed.
2. Press In-Room Indication button and press [HOLD/SAVE] button.
Conditions
1. If Supervisor station is not Idle, In-Room Indication button does not work.
2. If a station press the In-Room Indication button but the station is not supervisor, an
error tone is heard.
3. If [HOLD/SAVE] button is not pressed within 5 seconds after In-Room Indication
button pressed, the station goes back to the Idle state.
Programming
SYSTEM In-Room Indication (PGM 183)
Related Features
Hardware
To Next Page
Loading...