iPECS-LIK
Feature Description & Operation Manual
The call is routed to a forwarded station immediately, and the forwarded station is
ringing.
4. Answer the ringing at forwarded station. The calling and forwarded station can
make a conversation.
To deactivate Net Call Forward
1. Press the [FWD] button when it is flashing.
The [FWD] button will be extinguished.
Conditions
1. If both of served and diverted-to stations are located in the same system, the
networking path will be cleared. That is, the forwarded call will be setup as
intercom call.
2. System does not check the status of diverted-to station that is in DND, CFW or
Empty.
Networking Basic Attribute (PGM 320)
Networking Supplementary Attribute (PGM 321 –
BTN 1)
Networking CO Line Attribute (PGM 322)
Network Numbering Plan Table (PGM 324)
2.70.2.9 Net Call Forward – Busy
Description
It is possible for a user to forward his station remotely when the station is busy. The forwarded
destination can be over the network.
Engineering notice)
Currently, iPECS system supports both rerouting and join method by admin programming.
Operation
To activate Net Call Forward
1. Press the [SPEAKER] button and the [FWD] button.
2. Dial Net Call Forward code “2”, and dial the station number of another system. The
[FWD] button will be flashing and a confirmation tone will be provided if allowed.
3. Dial the station number that is set Net Call Forward to a station of another node.
The call is routed to a forwarded station when the called station is busy, and the
forwarded station is ringing.
4. Answer the ringing at forwarded station. The calling and forwarded station can
make a conversation.
To deactivate Net Call Forward
1. Press the [FWD] button when it is flashing.
The [FWD] button will be extinguished.
To Next Page
Loading...