Ericsson iPECS-100 - 8. SIP EXTENSION; 8.1 REGISTRATION

iPECS-LIK
Feature Description & Operation Manual
Issue 6.1
343
5.27 TWO-WAY RECORD
Description
An iPECS Phone user can record any active conversation to the station user’s mailbox or to
hard disk drive of an iPECS Phontage or UCS Client. All calls including incoming, outgoing,
internal, external, conference, conference rooms and conference group calls can be recorded.
A {RECORD} button must be assigned to access this feature.
Operation
iPECS Phone
To assign a flexible button as a {RECORD} button
1. [PGM] + {FLEX} + [PGM] + 80 + recording destination (optional) + [SAVE]
To activate Two-Way Record while on a CO/IP call
1. Press the {RECORD} button, record warning tone heard, and recording starts.
To stop Two-Way Record while on an CO/IP call
1. Press the {RECORD} again.
Or,
1. Hang-up, return to idle.
To manage the recordings, use the procedures outlined in the Phontage or UCS Client User
Guide.
Conditions
1. The {RECORD} button LED will flash at 240 ipm while recording.
2. This feature is available when using the VMIM/VSF VM, the Feature Server or using
an external AA/VM, which employs the SMDI communications mode. When an
external AA/VM system employs the in-band (DTMF) mode, Two-Way Record is
not available.
3. With the Feature Server or VMIM, internal calls can be recorded as well as external
calls.
4. Use of this feature when the Two-Way Recording Warn Tone is disabled may be
interpreted as a violation of federal, state, or local laws, and an invasion of privacy.
Check applicable laws in your area before recording calls using this feature.
5. If a destination for the recording is not defined for the {RECORD} button, the Call
Record Destination defined in PGM 112 is employed.
Programming
STATION
1
Two-way Record Privilege: ON (PGM 112-Btn 11)
2
Call Record Destination (PGM 112-Btn 21)
3
Auto Call Record (PGM 112-Btn 20)
SYSTEM
1
Two-way Record Warning Tone (PGM 161-Btn 19)