iPECS-LIK
Feature Description & Operation Manual
4. Dial 2-digit hour and 2-digit minute for alerting.
5. For a daily (repeating alarm), dial “#”.
6. Hook flash, conformation tone is provided.
To stop the alarm notification
1. Lift the handset.
To erase Wake-Up
1. Lift the handset.
2. Dial “562”, the SLT Programming code, confirmation tone is heard.
3. Dial “42”, the erase Wake-up code.
4. Hook flash, a conformation tone is provided.
Conditions
1. In cases where a remote device is installed, the time display in the remote terminal
is adjusted by the Device Zone assignment. Thus, the Wake-up alarm time is
based on the time displayed on the phone and not the system time.
2. When receiving a wake up signal, lifting the handset will return MOH.
3. The Wake-up alarm Ring signal is 30 seconds On/90 seconds Off repeated 3 times.
If no action is taken by the user, the ring signal is given to the Attendant with a
display designating the station number that did not respond.
4. Time (hh:mm) must be entered in the Military 24-hour format.
5. The daily alarm will reset and repeat each day until erased (cancelled). The One-
time alarm will reset and cancel automatically.
6. If you set 114-B24-B6 for WakeUp Announce, you can hear the system announce
number when you register wake-up.
Programming
PGM114-B24-B6 : WAKEUP ANNC(0-70)
Related Features
Hardware
To Next Page
Loading...