Ericsson iPECS-100 - Page 88

iPECS-LIK
Feature Description & Operation Manual
Issue 6.1
68
To delete a Conference Room
1. Press the [PGM] button.
2. Dial 54, the delete Conference Room code.
3. Dial the Conference Room number (1~9)
4. Dial the Conference Room password.
5. Press [SAVE] to delete the Conference Room.
To transfer a call to a Conference Room
1. Press the [TRANS] button.
2. Dial *59, the Conference Room entry code.
3. Dial the Conference Room Number.
4. Dial the Conference Room password.
5. Hang-up to complete the transfer.
SLT
To set-up a Conference Room
1. Lift the handset.
2. Dial 561, SLT Programming code.
3. Dial 53, the Create Conference Room code.
4. Dial the desired Conference Room number (1~9).
5. Dial the Conference Room password.
6. Momentarily press the hook-switch.
To join a Conference Room
1. Lift the handset.
2. Dial *59, the Conference Room entry code.
3. Dial the Conference Room Number.
4. Dial the Conference Room password.
To delete a Conference Room
1. Lift the handset.
2. Dial 561, SLT Programming code.
3. Dial 54, the delete Conference Room code.
4. Dial the Conference Room number (1~9).
5. Dial the Conference Room password.
6. Momentarily press the hook-switch, receive confirmation tone.
Conditions
1. Once established, a Conference Room will remain opened until the Room is deleted.
2. The Conference Room feature employs the Multi-party Conference Interface
Module (MCIM), which must be installed for proper operation.
3. iPECS Phontage and UCS Client may also create, delete and join a Conference
Room. For operation, refer to the iPECS Phontage or UCS Client User Guide.
4. Also use ISDN or SIP CO trunks for MCIM call control.