iPECS-LIK
Feature Description & Operation Manual
The No answer timer,
The busy/no-answer Retry count,
The Interval time: Each member is called in turn at expiration of the interval
timer.
4. Set the Member Attributes by entering:
Index number
Type: Station, Individual CO, CO group, loop or Transit-out code (access loop
for networking call).
The CO value: the supervisor wants to select a specific CO line or CO group.
Dial number: The station number or Co dial number.
Operation
IPECS phone
To assign a {GRP MONITOR} button
1. [PGM] + {FLEX} + [PGM] + “55” + [SAVE]
To initiate a Conference Group call:
1. Lift the handset.
2. Dial *68xxx, the Group Conference code and group number.
3. Enter the Conference group password, if assigned, members receive the
Conference Group call.
To enter a Conference Group call:
1. Answer the ringing call and receive recorded announcement, if assigned and
recorded.
2. Dial “1” to enter the conference or hang-up to reject the conference. For iPECS
Phontage or UCS clients, use Accept or Deny when notified of the conference.
To monitor member conference status or delete members while in the conference:
1. Press the Monitor flex button, the state of the first member is displayed.
2. Press [VOL UP/VOL DWN] button to display the state of other members.
3. Press the [DND] button to delete a participant from the conference.
To monitor the Group member conference status while Not in the conference:
1. Press the [PGM] button.
2. Dial 55, the Monitor Conference Group code.
3. Press [VOL UP/VOL DWN] button to display the state of other members.
To add a non-member to the Group:
1. Press the [HOLD] button to place the conference on hold.
2. Call the desired party.
3. Press the [CONF] button.
To Next Page
Loading...