Fujitsu PRIMERGY RX2540 M7

Using the iRMC S6 web interface
▶
Log in to the iRMC S6 web interface.
▶
Open the System menu.
▶
Open the Network page.
▶
In the Network Adapters group, you will find detailed information on each
network controller in the managed PRIMERGY server
, including its MAC
address.
This information is only available with the iRMC S6 or above. Only
network controllers supporting the Command Line Protocol (CLP) will
be displayed.
For add-in cards the vendors provide documentation and tools,
of
fered on the Fujitsu support web pages:
https://ts.fujitsu.com/support/
Select the server, select Downloads - More Details - Driver. Some
vendors bundle the documentation together with the driver package.
5.3.14.3 Looking for the WWN address of a fibre channel controller
There are several possible locations where these addresses can be found.
▶
Inform the customer about the new or changed WWN address.
Checking the label
▶
If available, check the label on the controller
. Beside the part number, you
may find the WWN address.
Using the BIOS
▶
Enter the BIOS setup menu.
▶
Select the Configuration menu.
Basic software procedures
RX2540 M7 Upgrade and Maintenance Manual 111