Fujitsu PRIMERGY RX2540 M7

4.14 Handling the rear air grids
4.14.1
Removing a rear air grid
Removing the rear air grid 1
Figure 38: Removing the rear air grid 1
▶
Remove the two screws (see circles).
▶
Remove the rear air grid 1.
CAUTION
Keep the rear air grid for future use.
▶
Always replace rear air grids into unused installation locations to
comply with applicable EMC regulations and satisfy
coolingrequirements.
Basic hardware procedures
RX2540 M7 Upgrade and Maintenance Manual 85