▶
T
o eject the iRMC microSD card, gently push it in and then let go (1).
▶
Pull the iRMC microSD card straight out of its slot (2).
CAUTION
(not valid for Europe, Middle East, India and Africa)
The iRMC microSD card contains customer information.
▶
After removing the iRMC microSD card, hand the card over to
the customer
.
▶
If the customer requests disposal of the defective microSD card,
proceed as follows: Using a pair of side-cutting pliers, cut the
microSD card in half.
Concluding steps
▶
If applicable, install the expansion card in slot 5 and 6, see "Installing an
expansion card" on page
269.
▶
"Reassembling" on page 59.
▶
"Connecting the power cord" on page 65.
▶
"Switching on the server" on page 71.
▶
If applicable, "Installing the front cover with lock" on page 71.
17.5.4 Replacing the iRMC microSD card
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Software: 20 minutes
(Firmware restore:
depending on configuration)
Tools: Phillips PH2 / (+) No. 2 screw driver (for cover 2)
Note on BIOS or iRMC S6 firmware restore feature
iRMC S6 firmware restore feature is executed at the same time as the power
cord is connected after the iRMC microSD card replacement.
System board and components
RX2540 M7 Upgrade and Maintenance Manual 507
To Next Page
Loading...
