Replacing the M.2 SSD
▶
Remove the defective M.2 SSD, see "Removing an M.2 SSD" on page
216.
▶
Install the new M.2 SSD, see "Installing an M.2 SSD" on page 212.
Concluding steps
▶
"Reassembling" on page 59.
▶
"Connecting the power cord" on page 65.
▶
"Switching on the server" on page 71.
▶
"Setting boot priority" on page 120.
▶
If applicable, "Installing the front cover with lock" on page 71.
▶
For non-array configurations, ask the customer or service engineer to install
the operating system or restore the data after the parts have been replaced.
Software configuration
To install the ESXi to the M.2 SSD, see "Software configuration" on
page 215.
7.8.5 Installing the M.2 interposer board
The M.2 interposer board is an option.
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
47.
▶
If applicable, "Removing the front cover with lock" on page 49.
Hard disk drive (HDD) / solid state disk (SSD)
RX2540 M7 Upgrade and Maintenance Manual 219
To Next Page
Loading...
