▶
"Switching on the server" on page
71.
▶
If applicable, "Installing the front cover with lock" on page 71.
▶
If applicable, update the system information of your server using the Chassis
ID Prom Tool, see "Using the Chassis ID Prom Tool" on page 113.
▶
"Updating expansion card firmware" on page 98.
▶
"Resuming BitLocker functionality" on page 107.
9.9.2 Removing an expansion card from a riser module
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Software: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Suspending BitLocker functionality" on page
89.
▶
If applicable, "Removing the front cover with lock" on page 49.
▶
"Shutting down the server" on page 50.
▶
"Disconnecting the power cord" on page 50.
▶
"Getting access to the component" on page 55.
▶
Remove the corresponding riser module, see "Removing a riser module" on
page 72.
Removing the expansion card from a riser module
▶
If necessary, disconnect the cables from the expansion card.
▶
If applicable, "Removing SFP+ transceiver modules" on page 258.
Expansion cards and backup units
RX2540 M7 Upgrade and Maintenance Manual 313
To Next Page
Loading...
