▶
Inform the customer about changed WWN, MAC and SAS addresses, see
"Looking for MAC/WWN/GUID and SAS addresses" on page
109.
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 106.
▶
"Setting boot priority" on page 120.
▶
"Updating expansion card firmware" on page 98.
▶
"Resuming BitLocker functionality" on page 107.
▶
If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
Configuration of network settings should be performed by the
customer
. For more information, see "Note on network settings
recovery" on page 315.
▶
If applicable, restore LAN teaming configurations, see "After replacing or
upgrading LAN controllers" on page
115.
9.9.4 Replacing a riser card
Field Replaceable Unit
(FRU)
Hardware: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page 47.
▶
If applicable, "Removing the front cover with lock" on page 49.
▶
"Shutting down the server" on page 50.
▶
"Disconnecting the power cord" on page 50.
▶
"Getting access to the component" on page 55.
▶
"Locating the defective component" on page 48.
Expansion cards and backup units
RX2540 M7 Upgrade and Maintenance Manual 317
To Next Page
Loading...
