The addresses are displayed at the one or more of the following (it depends on
the behavior of the UEFI driver included in each controller).
1.
The addresses are displayed at the UEFI driver menu included in each
controller in the Configuration
menu.
2.
Select the UEFI driver menu included in each controller. The addresses are
displayed at the help for the UEFI driver menu included in each controller.
3.
Enter the Network Device List menu. The addresses are displayed in the
Network Device List menu.
Only network controllers supporting the Command Line Protocol (CLP)
will be displayed.
5.3.14.4 Looking for the GUID address of an infiniband or Omni-Path
controller
▶
If available, check the label on the controller
. Beside the part number, you
may find the GUID address.
▶
Inform the customer about the new or changed GUID address.
5.3.14.5 Looking for SAS addresses of SAS controllers for external
devices
These addresses can be found using the iRMC S6 web interface.
▶
Log into the iRMC S6 web interface.
▶
Open the System menu.
▶
Open the Mass Storage page.
▶
Select the desired SAS controller.
▶
Expand the settings of the selected SAS controller. You can find data
including the SAS address.
For more information, see the "iRMC S6 - Web Interface" user guide.
▶
Inform the customer about the new SAS address. The customer need the
new SAS address, especially when the server is connected to a Fujitsu
Storage ETERNUS system.
Basic software procedures
112 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
