Concluding steps
▶
"Reassembling" on page
59.
▶
"Connecting the power cord" on page 65.
▶
"Switching on the server" on page 71.
▶
If applicable, "Installing the front cover with lock" on page 71.
▶
Update the system information of your server using the Chassis ID Prom
Tool, see "Using the Chassis ID Prom Tool" on page 113. Select the
corresponding system name.
▶
"Performing a RAID array rebuild" on page 108.
7.9.3 Upgrading with rear HDD cage 3
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Software: 10 minutes
Tools: – Phillips PH2 / (+) No. 2 screw driver
CAUTION
All data on all HDDs in the array will be lost when deleting the RAID
array!
▶
Be sure to back up your data before deleting a RAID array.
▶
For more information, see the "iRMC S6 - Web Interface" user
guide.
After installing or removing an additional backplane, never forget to
change the system information using the Chassis ID Prom T
ool.
Preliminary steps
▶
If applicable, "Removing the front cover with lock" on page
49.
▶
"Shutting down the server" on page 50.
▶
"Disconnecting the power cord" on page 50.
▶
"Getting access to the component" on page 55.
Hard disk drive (HDD) / solid state disk (SSD)
RX2540 M7 Upgrade and Maintenance Manual 233
To Next Page
Loading...
