▶
Install the two slot covers.
Concluding steps
▶
"Installing the crossbar" on page
84.
▶
"Installing the air duct" on page 79.
▶
If applicable, install the corresponding riser module, see "Installing a riser
module" on page 74.
▶
If applicable, install the corresponding rear air grid, see "Installing a rear air
grid" on page 87.
▶
"Reassembling" on page 59.
▶
"Connecting the power cord" on page 65.
▶
"Switching on the server" on page 71.
▶
If applicable, "Installing the front cover with lock" on page 71.
▶
If applicable, update the system information of your server using the Chassis
ID Prom Tool, see "Using the Chassis ID Prom Tool" on page 113.
▶
"Resuming BitLocker functionality" on page 107.
9.7.3 Replacing a GPU card from a riser module
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Software: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Note on network settings recovery
When replacing network controllers, network configuration settings in
the OS will be lost and replaced by default values. This applies to all
static IP address and LAN teaming configurations.
Ensure to note down your current network settings before replacing a
network controller
.
Expansion cards and backup units
RX2540 M7 Upgrade and Maintenance Manual 293
To Next Page
Loading...
