Preliminary steps
▶
"Suspending BitLocker functionality" on page
89.
▶
If applicable, "Removing the front cover with lock" on page 49.
▶
"Shutting down the server" on page 50.
▶
"Disconnecting the power cord" on page 50.
▶
"Getting access to the component" on page 55.
▶
Remove all riser modules, see "Removing a riser module" on page 72.
▶
"Removing an expansion card from a riser module" on page 313.
▶
If necessary, remove the cables from the expansion cards.
▶
"Removing the air duct" on page 80.
Removing the defective GPU card
▶
Remove the GPU card, see "Removing a GPU card from a riser module" on
page 290.
Installing the new GPU card
▶
Install the GPU card, see "Installing a GPU card in a riser module" on
page 284.
Concluding steps
▶
"Reassembling" on page 59.
▶
Connect all external cables to the expansion card(s).
▶
"Connecting the power cord" on page 65.
▶
"Switching on the server" on page 71.
▶
If applicable, "Installing the front cover with lock" on page 71.
▶
If applicable, update the system information of your server using the Chassis
ID Prom Tool, see "Using the Chassis ID Prom Tool" on page 113.
▶
"Updating expansion card firmware" on page 98.
▶
"Resuming BitLocker functionality" on page 107.
Expansion cards and backup units
294 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
