Figure 179: Installing the expansion card in a riser module
▶
Carefully insert the expansion card into the desired PCIe slot and press
down firmly until it is fully seated in the slot.
▶
If applicable, install SFP+ transceiver modules into the new expansion card,
see "Installing SFP+ transceiver modules" on page
252.
▶
If applicable, connect the FBU cable to the FBU, see "Installing an FBU" on
page 321.
CAUTION
Incorrect cabling may cause wrong LED identification of the HDD/SSD.
Misleading LED could lead to swapping out the wrong HDD/SSD, and
that will result in data loss.
▶
Check the correct cabling using the labels on the cables and the
cable plans.
Concluding steps
▶
Install the corresponding riser module, see "Installing a riser module" on
page
74.
▶
"Reassembling" on page 59.
▶
"Connecting the power cord" on page 65.
Expansion cards and backup units
312 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
