▶
While keeping the green locking latch pressed, pull the PSU out of its bay
(3).
CAUTION
Excessive temperatures could damage system components.
▶
Never leave the bay for the hot-plug PSU empty for more than
two minutes during operation.
Installing the dummy cover
Figure 51: Installing the dummy cover
▶
Insert the dummy cover into the empty bay with the impressed triangle
symbol pointing upward.
▶
Push the dummy cover into its bay until it locks in place.
CAUTION
▶
Always install dummy covers into unused bays to comply with
applicable EMC regulations and satisfy cooling requirements.
Power supply unit (PSU)
132 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
