Installing the OCP module
Figure 144: Installing the OCP module
▶
Push the OCP module into the slot. Ensure that the left cant fits into the
reccess.
▶
Fasten the OCP module with the knurled screw (see circle).
Concluding steps
▶
"Connecting the power cord" on page
65.
▶
"Switching on the server" on page 71.
▶
Configure the new MAC address in the OS, if you have no VIOM
(ServerView Virtual-IO Manager) installed. If you have VIOM installed, it is
not necessary to configure the MAC address. This is virtualized by VIOM.
▶
Inform the customer about new MAC addresses. For more information, see
"Looking for MAC/WWN/GUID and SAS addresses" on page 109.
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 106.
▶
"Configuring LAN teaming" on page 115.
Expansion cards and backup units
264 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
