Preliminary steps
▶
"Locating the defective server" on page
47.
▶
"Shutting down the server" on page 50.
▶
"Disconnecting the power cord" on page 50.
Removing the defective OCP module
▶
Remove the OCP module, see "Removing an OCP module" on page 265.
Installing the new OCP module
▶
Install the OCP module, see "Installing an OCP module" on page 262.
Concluding steps
▶
"Connecting the power cord" on page 65.
▶
"Switching on the server" on page 71.
▶
Inform the customer about changed WWN, MAC, GUID and SAS
addresses, see "Looking for MAC/WWN/GUID and SAS addresses" on
page 109.
▶
"Updating expansion card firmware" on page 98.
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 106.
▶
"Configuring LAN teaming" on page 115.
▶
If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced expansion card.
The configuration of the network settings should be performed by the
customer. For more information, see "Notes on network settings recovery"
on page 267.
Expansion cards and backup units
268 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
