Figure 148: Installing the expansion card
▶
Carefully insert the expansion card into the desired PCIe slot and press
down firmly until it is fully seated in the slot.
▶
If applicable, install SFP+ transceiver modules into the new expansion card,
see "Installing SFP+ transceiver modules" on page
252.
▶
If applicable, connect the FBU cable to the FBU, see "Installing an FBU" on
page 321.
▶
Fasten the screw (see circle).
Expansion cards and backup units
RX2540 M7 Upgrade and Maintenance Manual 271
To Next Page
Loading...
