Installing the internal RAID riser module
Figure 169: Connecting cables to the internal RAID riser module
▶
Connect the following cables to the internal RAID riser module:
1 HDD LED cable
2 SLIM SAS cable, depending on configuration
3 SLIM SAS cable, depending on configuration
4 Power cable
The cables are equipped with labels showing the right connector.
For the cable plan, see "Appendix B" on page
559.
CAUTION
Incorrect cabling may cause wrong LED identification of the HDD/SSD.
Misleading LED could lead to swapping out the wrong HDD/SSD, and
that will result in data loss.
▶
Check the correct cabling using the labels on the cables and the
cable plans.
Expansion cards and backup units
298 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
