Fujitsu PRIMERGY RX2540 M7

Installing the FBU in the FBU holder
Figure 188: Installing the FBU in the holder
▶
At a slight angle, fit the FBU under both retaining brackets of the FBU holder
as shown.
Notice the right position of the FBU cable:
OK
▶
Push in the FBU until it locks in place (1).
▶
Connect the FBU adapter cable to the FBU (2).
▶
If applicable, connect the FBU adapter cable to the corresponding RAID
controller
.
Expansion cards and backup units
324 Upgrade and Maintenance Manual RX2540 M7