▶
Install the OCP dummy cover or the OCP module, see "Installing the OCP
dummy cover" on page
266 or "Installing an OCP module" on page 262.
▶
Install the rear air grid 2, see "Installing the rear air grid 2" on page 88.
▶
Install the crossbar, see "Installing the crossbar" on page 84.
Concluding steps
▶
If applicable, install the riser module 1, see "Installing the riser module 1" on
page 74.
▶
"Installing the air duct" on page 79.
▶
"Reassembling" on page 59.
▶
"Connecting the power cord" on page 65.
▶
"Switching on the server" on page 71.
When the system is powered on after a CPU has been replaced or
upgraded, the Global Error indicator will start flashing with the message
CPU has been changed.
This only indicates that the CPU configuration has been altered. There
is no technical problem.
Proceed as follows:
●
Restart your server
.
●
As soon as the startup screen appears, press the [F2] function key to
enter the BIOS.
●
If a password is assigned, enter the password and press [Enter].
●
Select the Save & Exit menu.
●
Select Save Changes and Exit or Save Changes and Reset.
●
Verify that the Global Error indicator stops flashing.
▶
"Enabling replaced components in the BIOS" on page
102.
▶
"Resuming BitLocker functionality" on page 107.
Liquid cooling (LC)
388 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
