Tools: – Phillips PH2 / (+) No. 2 screw driver (for cover 2)
–
Torx Plus 6 screw driver (not valid for Japan)
– Phillips PH1 / (+) No. 1 screw driver (Japan)
Preliminary steps
▶
"Locating the defective server" on page
47.
▶
"Removing backup and optical disk media" on page 92.
▶
"Suspending BitLocker functionality" on page 89.
▶
"Checking boot priority" on page 93.
▶
If applicable, "Removing the front cover with lock" on page 49.
▶
"Shutting down the server" on page 50.
▶
"Disconnecting the power cord" on page 50.
▶
"Getting access to the component" on page 55.
▶
"Removing the fan cage" on page 76.
Removing the defective ODD
▶
Remove the ODD, see "Removing the ODD (2.5-inch chassis)" on
page 396.
Installing the new ODD
▶
Install the ODD, see "Installing the ODD (2.5-inch chassis)" on page 391.
Concluding steps
▶
"Installing the fan cage" on page 77.
▶
"Reassembling" on page 59.
▶
"Connecting the power cord" on page 65.
▶
"Switching on the server" on page 71.
▶
If applicable, "Installing the front cover with lock" on page 71.
Accessible drives
RX2540 M7 Upgrade and Maintenance Manual 401
To Next Page
Loading...
