Removing the ODD dummy cover
Figure 256: Removing the dummy cover
▶
Pull the dummy cover out of the bay
.
CAUTION
▶
Keep the dummy cover for future use.
▶
If you remove the accessible drive again and do not replace it with
a new one, the dummy cover must be reinstalled to comply with
EMC regulations and to satisfy cooling requirements and fire
protection measures.
Installing the ODD
▶
If no ODD has been installed before:
▶
Remove the two screws and take the ODD latch from the chassis (see
Figure 246).
Accessible drives
RX2540 M7 Upgrade and Maintenance Manual 403
To Next Page
Loading...
