▶
Push the locking latch in the direction of the arrow to lock the front panel
module.
Figure 279: Connecting the cable to the LTO drive
▶
Connect the L
TO cable to the LTO drive (1).
▶
Connect the end of the power cable to connector "PWR6" (2) on the system
board.
▶
Connect the end of the SAS cable to connector "C0" (3, close-up) on the
RAID card.
For the cable plan, see "Appendix B" on page
559.
Concluding steps
▶
"Installing the fan cage" on page
77.
▶
"Reassembling" on page 59.
▶
"Connecting the power cord" on page 65.
Accessible drives
RX2540 M7 Upgrade and Maintenance Manual 427
To Next Page
Loading...
